• Company/Home
  • About Us
  • Testimonials
  • Corporate Marketing
  • Employment
• Laser College
• Skin Care
• Marketing
• Terms
• Contact Us
• Price List

Products

• Algonix Pain Management
• Beds,Tables Chairs
• Beautytek Body Contouring
• Cavitation Fat Reduction
• CosMedic Lasers/IPL's/LED's
• Microdermabrasion
• Micro Channeling
• Small Equipment
• Stools/Trollies
• Pedicure Chairs/Spas
• Manicure Tables/Pedi Stools
• Cabinets/Shelves
• Day Spa Wear & Linens
• Supplies

  ---

 



Cleaning Your Crystal Clean™ Pipe-Free Spa

It is extremely important to clean and disinfect every pedicure spa after every pedicure, after the last pedicure of the day, and once a week for overnight cleaning.
Proper cleaning and disinfection will keep the spa in good working condition, and most importantly, eliminate harmful bacteria that can harbor in tiny crevices unseen by the naked eye.
To clean and disinfect the pedicure spa, follow these easy steps :

 

After Every pedicure:

1. Drain water from the spa by turning the drain handle to the “Open” position.
2. Loosen the footplate by turning the footplate knobs in a counter-clockwise direction. Remove the footplate from the basin by lifting upward on the Inlet Cover (NOTE: gently press down on the footplate center when loosening the footplate knobs, as this will relieve pressure and help loosen them.)
3. Using a non-abrasive brush with soap and water, remove all visible residue from the inside of the basin and all other components. Rinse the basin with the water sprayer.
4. Spray the basin and all other components with an EPA registered disinfectant or solution containing 10% bleach. *EPA disinfectants require 10-minute contact.
5. Thoroughly wipe the basin and all other components dry with a clean towel.
6. Replace the footplate and secure by simultaneously turning both footplate knobs in a clockwise direction. (NOTE: when replacing the footplate, carefully align the mounting studs with the mounting holes. Tighten each knob until snug. Be careful not to overtighten as this can damage the knobs.)

After the Last Pedicure of the Day, and After the Following Above Steps: Fill basin with warm water to the fill line.

1. Fill basin with warm water to the fill line.
2. Pour three teaspoons of low-foaming dishwashing detergent (such as Cascade) and two ounces of household bleach in basin.
3. Turn on the whirlpool jets and let run for 10 minutes.
4. Turn the jets off and drain water from the basin.
5. Spray the basin and all other components with the with the water sprayer.
6. Refill the basin with clean water to rinse.
7. Turn the jets on and run for 1 minute.
8. Drain water from the basin and turn off the whirlpool jets.

Once a Week Overnight Cleaning:

In addition to the daily cleaning, the following cleaning procedures must be done every week.

1. Fill the tub basin with warm water to the fill line.
2. Pour three teaspoons of low-foaming dishwashing detergent (such as Cascade) and two ounces of household bleach in basin.
3. Turn on the whirlpool jets and let run for 10 minutes. Let the water sit overnight in the tub (six - 10 hours).
4. In the morning, run the whirlpool jets for five minutes and drain the tub basin.
5. Follow the procedures done after every pedicure.

The procedures done after every pedicure.

CAUTION:
Cleaning products that contain abrasives can damage the pedicure spa. Use ONLY non-abrasive products to clean the spa. Check with State rules and regulations for additional cleaning and disinfecting procedures.